![]() ![]() "^\UF729" = "moveToBeginningOfDocument:" "$\UF72B" = "moveToEndOfLineAndModifySelection:" "$\UF729" = "moveToBeginningOfLineAndModifySelection:" Home and End doesn't go to front/end of current line.Įnter the following in Terminal, enter after each line. ![]() For the Command (⌘) Key setting, select (⌥) Option.Ĥ.For the Option (⌥) Key setting, select ⌘ Command.Select your third-party Windows keyboard via the Select keyboard drop down box.System Preferences → Keyboard → Modifier Keys.May need to tap Numlock a few times to test. Trick: for some reason, if the Toggle palette doesn't show OFF - ON, cut and paste it may solve the problem.Drag the Off from one pallete to another to connect it.Select Controller - select MasterKeys Pro M Single - Keyboard (not System Control) - find Numlock Building Block in the LEDs section.Select Controller - find MasterKeys Pro M Single - Numlock (Keyboard) (not System Control) in the LEDs section.Find Toggle - set Initial/Reset Value to On.In the Palette window - select Logic - find On/Off Gate.In the Palette window - select Controller - select MasterKeys Pro M Single - Keyboard (not System Control) - in Controls section find MasterKeys Pro M Single - Keyboard Numlock and Clear drag it to the programming page.In the Palette window - select Controller - find MasterKeys Pro M Single - Keyboard Numlock and Clear (Keyboard) (not System Control) - drag it to the programming page.After installation, right click in the Programming Items panel - Create Programming Page.If a Driver not install pop up, re member the item in System Preferences is Security
0 Comments
Leave a Reply. |